Step 1:
This paper is for the tiny flowers.
The size is 1,5x1,5 inch or 4x4 centimeters.
Prefold in half over these 2 lines.

Step 2:
Valley-fold over these four lines.

Step 3:
Fold the four corners outwards.

Step 4:
Fold in half

Step 5:
Pull the 2 corners at the pink dots towards each other, in the direction of the yellow arrows. Then lay the piece at the pink dot on the left over the backside of the piece indicated by the dot on the right.

Step 6:
Hold the model the same as I do in this picture. Make a valley-fold on the bottom of the flower, see yellow arrow.

Step 7:
Make another valley-fold on the bottom of the flower. You actually just roll a piece of the bottom of the flower up in step 6 and 7.

Step 8:
First, press a piece of the bottom of the flower inwards, see small arrow.  zie kleine pijl.
Then press on the bottom from aside with two fingers, see large arrows.
The model won't open by itself anymore after you've made the folds from step 6 to 8.

Step 9:
This is the bottom of the flower. Curl or press each petal (see arrows) a little bit downwards..

Step 10:
One flower is done...
Make about 20 of these flowers for one complete arrangement.

Step 11:
Make 5 of these leaves. 
Click here to see diagrams for making these leaves 
I used papers of 6x6 inch or 15x15 centimeters for making these leafs.

Step 12:
Make 2 stems of about 7 inch or 17 centimeters and one stem of 5,5 inch or 14 centimeters.
Click here to see instructions for making a stem
If your stem is to thick, just fold it in half over the length one more time

Step 13:
Make a tiny stem like this one for each flower.
Click here to see diagrams for making a tiny stem
I used papers of 1x1 inch or 2,5x2,5 centimeters to make these stems

Step 14:
Fold the end of a tiny stem downwards and add a little glue to the piece you've folded downwards. Then glue the bottom of a flower to this piece.

Step 15:
Bend or curl the stem a little, see yellow arrows.

Step 16:
Add a little glue to the bottom of the tiny stem and glue it to the large stem, see arrow on the left.
Glue about 6 or 7 tiny stems with flower to the larger stem. Let the flowers hang downwards a little, by curling each tiny stem.

Step 17:
Make 3 of these flowering tops for one complete arrangement.

Step 18:
The 3 flowering tops are placed in a pot filled with foam. The pot I've used is 3 inch or 7 centimeters in height.
The leaves are placed in the foam too, around the flowering tops.




Finally, I placed origami sand on top of the foam, to cover it.
Click here for instructions to make the origami sand.