Home - Gallery
- Contact - My upper floor - Videos -
Privacy Policy
ORIGAMI AZALEA
This origami azalea is not very difficult to make.
Step 1:
Prefold over these 4 lines.
Step 2:
Make a valley-fold over these 4 lines.
Step 3:
Fold the 4 ends back to the outside of
the model by
making a valley-fold over these lines.
Step 4:
Prefold over these 4 lines.
Step 5:
Fold 3 ends to the inside by making a
valley-fold over
these three lines.
Step 6:
Turn the model.
Step 7:
Pull the piece between the 2 lines to
the left by making
a valley-fold over the line on the left
and a mountain-fold
over the line on the right.
These lines are already prefolded.
Step 8:
Repeat step 7 two times over these 2
pairs of lines.
(All lines are prefolded).
Step 9:
Make the same kind of folds as in step 7
over these 2 lines.
And make the same 2 folds at the place
indicated by the
arrow.
Step 10:
Now the model looks like this.
Step 11:
Hold the model upside-down the same as I
do.
Then, press the bottom of the flower
flat from aside,
see arrows.
Step 12:
Turn the model.
Step 13:
Hold the petal between two
fingers at the place indicated
by the green dot. Then press the end of
the petal flat
from aside between two fingers of your
other hand,
see
the 2 large arrows at the bottom in this
picture.
Repeat these folds on the other 4
petals, see
smaller arrows.
Step 14:
The flower is done....
Step 15:
This paper is for the leaves
of the azalea.
Both sides of the paper are coloured.
Make a valley-fold over these 2 lines.
Step 16:
Make a valley-fold over the
line on the left and then
a mountain-fold over the line on the
right.
Step 17:
Make a valley-fold over this line.
The corner indicated by the arrow is
pulled a bit upwards
while you make this fold.
Step 18:
Press the model flat from above on the
place indicated
by the arrow.
Step 19:
Repeat step 17 and 18 over this line.
Step 20:
Make a valley-fold over these 4 lines.
Step 21:
Turn the model.
Make 5 of these leaves.
Glue the stem of each leaf to the
backside of the
flower.
Done!