Step 1:
I used light pink papers of about 3x3inch for the flowers. Roll it up in your hands

Step 6:
Make enough of these pink bells for one arrangement.

Step 5:
Press the edge inwards by making a mountain-fold over this curved line. Do the same on the right flower.

Step 2:
I'm holding one of my fingers inside the tube now. Press the center inwards from aside with your other hand.

Step 4:
Valley-fold over this yellow line

Step 3:
If the model is crumpled to much, push it outwards from the inside with your finger, see arrow.

Step 10:
Valley-fold over these 2 lines

Step 8:
Valley-fold over these 2 lines

Step 9:
Valley-fold over these 2 lines.

Step 7:
The leaf paper is also 3x3inch.
Prefold in half.

Step 16:
Insert metal wire in the stem. Then valley-fold the stem in half over the length. Make enough stems for one arrangement.

Step 15:
This paper is for the stems. Valley-fold over these 2 lines, then turn the model

Step 12:
Turn the model

Step 11:
Valley-fold over this line.

Step 14:
Make enough leaves for one arrangement

Step 13:
Hold the model the same as I do. Press the tip to the left with your other hand, so the leaf gets wrinkled a little

Step 19:
This is a top view of the Bonsai Bell Flowers.

Step 18:
I glued this leaf in the opening edge of the stem,  see arrow, to make the glueing more easy. Make enough of these parts for one arrangement,  vary in length of the stems and amount of leaves and flowers

Step 17:
Glue the flower(s) and leaf(s) to the stem. Curl/curve the stem