Step 1:The backside of the paper is completely white.
Turn the paper.
Step 2:
Prefold over these 4 lines.
Step 3:
Make a valley-fold over these 2 lines.
Step 4:
Make a valley-fold over these 2 lines.
Step 5:
Make a valley-fold over these 2 lines.
Step 6:
Make an inside reverse fold over the 3 blue lines
(=mountain-fold over the line in the middle and
a valley-fold over the 2 outer lines).
Make the same folds at the place indicated by the arrow.
Step 7:
Make an inside reverse fold over these 3 lines
(=mountain-fold over the very short line in the middle
and a valley-fold over the 2 longer lines).
Make the same folds on the edge indicated by the arrow.
Step 8:
Make a mountain-fold over this line.
Step 9:
Make an inside reverse fold over these 3 lines.
The edge indicated by the arrow below is folded to
the edge indicated by the upper arrow.
Step 10:
Make an inside reverse fold over these 3 lines.
(=valley-fold over the line in the middle and
a mountain-fold over the 2 longer lines).
Step 11:
Now the model looks like this.
Step 12:
Hold the model the same as I do.
Then pull the neck a little to the right with your other
hand, see arrow.
Step 13:
And now the model looks like this.
Turn the model upside down.
Step 14:
First, make a valley-fold over the line on the right.
Then, make a mountain-fold over the other line.
Step 15:
Make a valley-fold over this line.
The corner indicated by the arrow is pulled upwards
while you do this.
Step 16:
The arrow shows the corner of step 15.
Press the place at the arrow flat from above.
Step 17:
Repeat steps 15 and 16 on the other side of the tail,
see blue line.
Step 18:
Fold the model in half over the blue line.
Then, turn the model.
Curl/bend the tail upwards, see arrows.
