Step 1:This is the front of the paper.
Turn the paper.
Step 2:
Roll up the paper, make sure the coloured part
is on one side of the model.
Step 3:
Hold the model the same as I do in this picture.
Press the model carefully inwards on the places
indicated by the arrows (also on the backside).
Make sure the white part isn't pressed inwards.
Step 4:
Press the place at the arrows inwards from all angles
as far as possible.
Step 5:
Twist the piece from step 4 clockwise a little, see arrow.
Now this piece becomes a little thinner and stronger.
Step 6:
Hold the model the same as I do in this picture.
Hold the place indicated by the small arrows in your
other hand and push it a little to the left, in the direction
of the large arrow. Push it inside the white part of the
model.
Step 7:
Now the white part has an edge that stands upwards.
Make a valley-fold over the 2 green lines.
Step 8:
The top of the candle is ready...
Step 9:
This is the bottom of the candle.
Hold the model the same as I do in this picture.
Press the edge inwards at the place indicated by
the arrow.
Step 10:
Press the edge inwards on more places,
see arrows as examples.
These folds are to make sure the bottom of the
candle can't open by itself anymore.
Step 11:
Now the bottom of the candle looks like this.
Done!
Could be a nice christmas-card...
