Step 1:Both sides of the yellow paper are coloured.
Make mountain- and valley-folds over these 4 lines.
Unfold each fold after you've made one.
Step 2:
Make these folds from the edge of the paper to the center,
not any further.
First, make 2 valley-folds below, on the right. Then, make
2 mountain-folds in the middle. And make 2 valley-folds
on top, on the left.
Now you get a basic shape.
Step 3:
Fold the end at the bottom of the arrow upwards by
making a valley-fold over the blue line.
Step 4:
Fold the piece on the right of the blue line to the left
by making a valley-fold over this blue line.
Step 5:
Fold the end at the bottom of this arrow upwards by making
a valley-fold over the blue line.
Repeat step 3 to 5 on the backside of the model.
Step 6:
Fold the end at the arrow upwards a bit by making a
valley-fold over the blue line.
Step 7:
Make an inside reverse fold over the short blue lines.
Do this by making a mountain-fold over the line on the left
and a valley-fold on the same place at the backside of the end.
Make a valley-fold over the line on the edge of the end, this
line is on the right in the picture.
You actually just push the end indicated by the arrow to the
inside of the model when you make these folds.
Step 8:
Repeat step 7 on the other 3 ends of the model, see arrows.
Step 9:
Open the bottom of the model, by pulling the edges indicated
by the 2 arrows outwards.
Step 10:
Press the 2 layers at the 2 short blue lines on the right in the
picture against each other. The lock these 2 layers together
by making a valley-fold over the 2 blue lines in one time.
(The 2 blue lines are on the same place after you've pressed
the 2 layers against each other).
Do the same as above on the 3 other places, see arrows.
Step 11:
Press the corners indicated by the 4 arrows towards each other.
Then, place the model on the table the same as I did in the
picture of step 12.
Step 12:
Press the end at the flat side of the arrow outwards,
in the direction of this arrow.
Make sure that the 2 blue lines on the edge below are
in one straight line after you've done this.
Do the same as above with the other 3 ends in the middle
of the model.
Step 13:
Press the paper on the places indicated with the pink dots
a bit upwards from below, so the crown is less edgy in the
middle.
The origami crown is ready!
Here's a funny frog with a crown on his head.
