This
is not a very difficult dino-model, but it does look real cool Step
1:
This is the front of the paper, the other side
is the same, but has no eyes printed on.
Prefold over these 2 lines
Step
2: Fold over these 3 lines
Step
3:
Mountain-fold over the line below and valley-fold
over the upper line.
Do the same on the backside
Step
4:
Press the end on the right to the left by folding
over these 2 lines. Make the same folds on the
backside (mirror-wise)
Step
5:
Open the model from below, see arrow
Step
6:
Valley-fold over this line, the corner indicated
by the arrow is pulled upwards while you do this.
Step
7:
Press the place indicated by the arrow flat
Step
8:
Repeat step 6 and 7 on the other side of
the tail.
Step
9:
Repeat steps 4 to 8 on the other side,
use the yellow lines as starting point (they are
placed a little further from the center then the
lines of step 4)
Step
10:
Press the edge inwards by making an inside reverse
fold over these 3 lines
Step
11:
Make another inside reverse fold on the edge
Step
12:
Repeat steps 10 and 11 on the other side,
see arrow
Step
13:
Pull the leg on the left a little to the right by
folding over the 2 lines on the left.
Pull the leg on the right a little to the left by
folding over the 2 lines on the right.
Do the same on the other side of the model
Step
14:
Hold the neck between your fingers on the spot
indicated by the blue dot.
Then, press the head flat with your other hand,
against the fingers which are holding the neck.
Use the yellow lines as help (make the same 2 folds
on the other side of the head, mirror-wise)
Step
15:
Mountain-fold over the upper line and
valley-fold over the line below.
Step
16:
Valley-fold over this short line
Step
17:
Mountain-fold over this yellow line,
do the same on the other side of the neck.
Step
18:
Mountain-fold over this line,
do the same on the other side of the tail.
Step
19:
Push/fold/bend the tip of the tail to the left
(=upwards in this picture)
Step
20:
Mountain-fold on the upper layer. Valley-fold
on the same place on the layer below
Step
21:
Hold the brown part between your fingers. Then push
it downwards a little, in the direction of the arrow.
Step
22:
Pull the brown part to the left on 3 places by
folding over these 3 pairs of yellow lines
DONE!
This is a video with instructions for folding the Dimetrodon-Dino: