The folding paper for this ghost is completely white, I only drawed a funny face on it later.
Step 1:Prefold over these 4 lines.
Step 2:
First, make a valley-fold over the 2 lines below, on the right.
Then make a mountain-fold over the 2 lines in the middle.
And make a valley-fold over the 2 lines on the upper left.
Step 3:
Make a valley-fold over these 2 lines.
Make these folds over the upper 2 layers of paper.
Step 4:
Unfold the folds of step 3.
Step 5:
Pull the end at the bottom of the arrow upwards
by making a valley-fold over the blue line.
Step 6:
Press the edges that stand upwards flat from above,
see arrows.
You don't have to make new folding lines to do this.
Step 7:
Repeat steps 3 to 6 on the backside of the model.
Step 8:
Fold the piece above the blue line downwards
by making a valley-fold over this blue line.
Do the same on the backside of the model.
Step 9:
Draw a simple/funny/scary face on the place indicated
by the arrow.
You can draw the same face as I did, but many other
faces will do the job.
Step 10:
Fold the piece on the right of the blue line to the left
by making a valley-fold over this blue line.
Step 11:
Make an inside reverse fold over these 3 lines. Do this by
making a valley-fold over the 2 short lines and
a mountain-fold over the longer line in the middle.
You actually just pull the end indicated by the arrow
upwards when you're making these folds.
Step 12:
Push the piece of step 10 back to the right, see arrows.
Step 13:
Repeat steps 10 to 12 on the other side of the model,
see arrow.
Step 14:
Make a mountain-fold over these 2 lines.
Do the same on the backside of the model.
Step 15:
Make a mountain-fold over this line.
Step 16:
Hold the arm of the ghost between two fingers on the
place indicated by the blue dot.
Then, press the end flat from above and below with
your other hand.
Do the same as above on the other arm.
Step 17:
Push the arms a little to the front by making
a valley-fold over these 2 lines.
Step 18:
First, make a valley-fold over the upper line. Then,
make a mountain-fold over the short line below.
Make the same folds on the piece at the backside
of the model.
Now you've made two pieces on which the ghost can
stand.
