Home - Gallery
- Contact - My upper floor - Videos -
Privacy Policy
Horror Origami Ghost
The
paper I used is a square which I cut out of a white A4 printer/copy
paper
Step
1:
Prefold over these 4 lines.
Step
2:
First valley-fold over the 2 lines at the bottom-right.
Then mountain-fold over the 2 diagonal lines in the
middle. And valley-fold over the 2 lines at the top-left.
Step
3:
Valley-fold over these 2 lines.
Step
4:
Unfold the folds of step 3
Step
5:
Valley-fold the tip at the bottom of the arrow upwards
Step
6:
Push/press the edges indicated by the arrows
downwards
Step
7:
Valley-fold the flap downwards
Step
8:
Repeat steps 3 to 7 on the backside
Step
9:
Make an inside reverse fold over the three blue
lines. Valley-fold over the pink line while you do this
Step
10:
The arrow shows the tip of step 9.
Repeat step 9 on the backside of the model
Step
11:
Pull the tip upwards by making an outside reverse fold
over the three blue lines (=valley-fold of all 3 lines).
Fold the model in half over the pink line while you
do this.
Step
12:
Valley-fold over this line
Step
13:
Mountain-fold over this line
Step
14:
Press the hand flat between your fingers,
see arrows.
Step
15:
Push/bend/fold the tip of the hand to the right,
see arrow
Step
16:
Repeat steps 12 to 15 on the other side,
see arrow
Step
17:
Press the place indicated by the arrow flat
Step
18:
Push one layer of the edge indicated by the arrow
to the right.
Do the same on the other side of the model.
Step
19:
Push one layer of the edge indicated by this arrow
to the right too. Do the same on the other side.
Hold the two ends on the head between your fingers
and rotate them counter-clockwise, see upper arrow.
DONE !
Where the $#@ are they going?!