Step 6:
Fold over these 2 lines.

Step 5:
Valley-fold the spot on the right to the spot
on the left, see arrow.

Step 2:
Prefold over these 2 lines

Step 4:
Valley-fold in half.

Step 3:
Repeat steps 1 and 2 over these lines

Step 10:
Valley-fold over these prefolded lines.

Step 8:
Valley-fold over this line.

Step 9:
Unfold the model.

Step 7:
Mountain-fold over this line.

Step 1:
The backside of this paper is kept white, to
make the instructions more clear.
Prefold over this line, then turn the paper.

Step 16:
Press the spots indicated by the arrows
a little more flat.

Step 15:
Press the outer part of the flower flat on
the table.

Step 12:
Pull the spots at the bottom of the arrows
upwards by folding over these lines.

Step 11:
Turn the model

Step 14:
Fold over these 3 lines

Step 13:
Repeat step 12 over these lines.

Step 21:
Mountain-fold these 4 corners to the backside.

Step 19:
Pull this edge open, see pink arrow.

Step 20:
Make an inside reverse fold over these 3 lines.
Do the same on the left, see arrow.

Step 18:
Make an inside reverse fold over these 3 lines.
Do the same on the left, see arrow.

Step 17:
Pull this edge open, see pink arrow

Step 22:
Mountain-fold over these 2 lines.
Then, turn the model.

Step 28:
Press both edges flat, see arrows.

Step 25:
Valley-fold over this line.
Then, turn the model again.

Step 26:
Mountain-fold on the corners, to make the
flower more round / natural.

Step 24:
Press the spot indicated by the arrow flat.

Step 23:
Valley-fold over this line. The corner indicated by
the arrow is pulled upwards while you do this.

Step 29:
Make 4 flowers for one plant.

Step 27:
Pull these edges outwards, you can do the
same with the edges on the other side of the
stamen.

Step 30:
The leaf papers have the same size as the
flower papers.
Mountain-fold over these 2 lines.

Step 31:
Mountain-fold over these 4 lines.

Step 32:
Curl/curve the leaf by rolling it up in your hands.

Step 34:
Cut 4 stripes out of a leaf paper. Then,
glue or tape them together into one stem paper.
Valley-fold over these 2 lines.

Step 33:
Make 5 leaves for one plant.

Step 35:
Insert a metal / florist wire into the stem

Step 36:
Valley-fold the stem in half over the length.
Then, curve / bend the stem into the right shape,
see next step.

Step 37:
This should be the right shape for the stem.
The flowers are glued to the right part, which
is hanging down.
The leaves are glued to the bottom of the stem,
on the left (just a bit above the fingers which are
holding the stem in this picture).