Step 2:
Valley-fold over these 2 lines.

Step 1:
The other side of this rhino-paper is white.
Prefold in half over this line,
then turn the paper.

Step 3:
Valley-fold over these 2 lines.

Step 4:
Pull the layer indicated by the 2 arrows
a little to the right.

Step 5:
Repeat step 4 on the left,
see arrow.

Step 6:
Mountain-fold over this line.

Step 7:
Press the model flat again, see arrows.

Step 8:
Push the 2 flaps indicated by the arrows
downwards again.

Step 9:
Valley-fold the model in half.

Step 10:
Pull the corner indicated by the arrow to the
left by making a valley-fold over the line on the
left and a mountain-fold over the line on the right.

Do the same on the other side of the model.

Step 11:
Pull the spot indicated by the arrow to the left by
making a valley-fold over the line on the right and
a mountain-fold over the line on the left.

Do the same on the other side of the model.

Step 12:
Open the model, see arrows.

Step 13:
Mountain-fold over the line on the left and
valley-fold over the line on the right.

Step 14:
Valley-fold over the line on the left and
mountain-fold over the line on the right.

Step 15:
Valley-fold over this line.
The corners indicated by the arrows are
pulled upwards while you do this.

Step 16:
Press the spots indicated by the 2 arrows flat.

Step 17:
Repeat steps 15 and 16 on the other side,
see arrow.

Step 18:
Valley-fold over this line. The corner indicated by the
large arrow is pulled upwards while you do this.
Then press this corner flat.

Do the same as above on the other side,  see small arrow.

Step 19:
The arrow shows the first corner of step 18

Turn the model.

Step 20:
Push the head to the right by making a mountain-fold
over the 3 lines on the left and a valley-fold over
the 2 lines on the right.

Step 21:
This is step 20 from aside.

Step 22:
Now step 20 is done

Step 23:
Valley-fold over this line.

Step 24:
Press the tip flat between your fingers by making
a valley-fold over the upper line, see arrows.
Then push the tip to the front by making a
valley-fold over the 2 lines below.

DONE!                                                  



This is a video with Joost Langeveld folding the rhino: