Only the front of the square piece of paper is coloured.
Step 1:This is the front of the paper.
Turn the paper.
Step 2:
Make mountain- and valley-folds over the 4 lines.
Unfold each fold after you made one.
Step 3:
Make these folds from the edge of the paper to the center,
not further. First, make 2 valley-folds below, on the right.
Then make 2 mountain-folds in the middle.
And make 2 valley-folds on top, on the left.
Now you have a basic-shape.
Step 4:
Make these valley-folds on the upper 2 layers of the model.
Unfold the folds after you made them.
Step 5:
Pull the end at the bottom of the arrow up by making
a valley-fold over the yellow line.
Step 6:
Press the edges that stand upwards (see arrows) down.
Use the folds you made in step 4 as help-lines.
Step 7:
Repeat step 4 to 6 on the backside of the model.
Step 8:
Make a valley-fold over this line.
Step 9:
Make a valley-fold over this line.
Step 10:
Make a valley-fold over this line.
Step 11:
And make a valley-fold over this line.
Step 12:
Fold the piece on the backside of the model (see large arrow)
downwards. Do this by making a mountain-fold over the invisible
line between the 2 smaller arrows.
Step 13:
Fold the piece on the left of the yellow line to the right
by making a valley-fold over this yellow line.
Step 14:
Fold the end at the arrow upwards by making
an inside reverse fold over the 3 lines.
(The 2 lines on top lay a little bit diagonal)
Step 15:
Repeat step 14 on the end that is indicated with the arrow.
Step 16:
Fold the piece on the right of the yellow line to the backside
by making a mountain-fold over this line. Make this fold over
the upper 2 layers of the end.
Then, make a valley-fold on the same place over the 2 layers
below.
Step 17:
Fold the end in half over this yellow line.
Step 18:
Repeat step 16 and 17 on the end on the left (see arrow)
The shrimp is ready!
