Step 1:
I used 6x6 inch papers for the flowers, they're green on one side.
Fold in half.

Step 6:
Fold the edge to the prefolded line, see arrow.

Step 5:
Prefold this part in half, see arrow

Step 2:
Prefold in half

Step 4:
Prefold the edge in half, see arrow

Step 3:
Fold the edge to the prefolded centerline, see arrow.

Step 10:
Fold over these six lines

Step 8:
Prefold, use the white centerline as guidance.
Unfold the model afterwards.

Step 9:
Cut over these prefolded lines, into a hexagon shape

Step 7:
Fold along the edge.

Step 16:
Fold the flap downwards.
Repeat steps 13 to 16 two more times

Step 15:
Fold / press these edges downwards

Step 12:
Fold over the prefolded lines, into a basic shape.

Step 11:
Prefold over these lines.

Step 14:
Fold over this line.

Step 13:
Prefold over these two lines, see arrow as example

Step 21:
I used 3x3 inch papers for the tiny stems. Roll up around your finger.

Step 19:
Curve the six petals outwards by rolling them up.

Step 20:
Done....

Step 18:
Hold two edges in one hand. Then squash-fold this inner petal outwards, see arrow.
Squash-fold two more petals, to get three inner petals and three outer.
Work symmetrical.

Step 17:
Fold over these two lines, repeat two more times, see arrows.

Step 22:
Press the right part flat.

Step 28:
Fold over these two lines.

Step 25:
Glue a flower into the stem

Step 26:
Done....

Step 24:
Fold in half and curve the stem.

Step 23:
Fold in half

Step 29:
Fold over the two outer lines and then in half over the white line.

Step 27:
I made large leaves out of 6x6 inch papers and smaller ones of 3x3 inch papers.
Fold over these two lines.

Step 30:
Curve the tip of the leaf.

Step 31:
Done.....

Step 32:
Fold a long rectangle around a metal / florist wire.

Step 33:
Glue about two large leaves to the lower part of the stem. And glue a small leaf and one to three flowers to the top of the stem.