Step
2: Valley-fold over these 3 lines, each section
has the same size.
Step
3: Open the model again.
Step
4: Fold over these 3 lines
Step
5: Make the same fold on the other side
Step
6: Open the model by making a mountain-fold
over this line.
Step
7: Fold over these 2 lines.
Step
8: Fold the model in half again.
Step
9: Open the back of the model and turn it
upside down.
Step
10: Push this corner to the left by making
an inside reverse fold over these 3 lines.
Step
11: Valley-fold over this line.
Step
12: Repeat steps 10 and 11 on the other side,
see arrow
Step
13: Press the tip flat between your fingers, see arrows. Do this by making a valley-fold over the 3 blue lines
and a mountain-fold over the 2 yellow lines.
Step
14: Make an inside reverse fold on the edge,
the short line in the middle is a mountain-fold.
Step
15: Push the ear upwards, see arrow
Step
16: Repeat steps 13 to 15 on the other side
Step
17: Make the same fold on the other side, mirrorwise
Step
18: Mountain-fold over this line
Step
19: Make the same inside reverse fold on the other side. Finally, draw eyes on the model, see final picture.
DONE!
The big one is a piggy bank.
In this How-to-video Joost Langeveld shows us how to fold the
baby pig: