Only the front of the square piece of paper is coloured.
Step 1:This is the front of the paper.
Turn the paper.
Step 2:
Make mountain- and valley-folds over the 4 lines.
Unfold each fold after you made one.
Step 3:
Make these folds from the edge of the paper to the center,
not further. First, make 2 valley-folds below, on the right.
Then, make 2 mountain-folds in the middle.
And make 2 valley-folds on top, on the left.
Now you get a basic shape.
Step 4:
Make these 2 valley-folds over the upper two layers
of the model.
Step 5:
Unfold the folds you made in step 4.
Step 6:
Pull the end at the bottom of the arrow up
by making a valley-fold over the blue line.
Step 7:
Flatten the edges that stand upwards, see arrows.
Use the folds you made in step 4 as help-lines.
Step 8:
Repeat step 4 to 7 for the backside of the model.
Step 9:
Fold the piece above the blue line down by making
a valley-fold over the blue line.
Then, turn the model, see yellow arrow.
Step 10:
Make a mountain-fold over the blue line.
Step 11:
Make a mountain-fold over this line.
Step 12:
Fold the piece you folded to the backside back to the
front by making a valley-fold over the blue line.
Make this fold just a little bit below the edge of the
grey piece.
Step 13:
Repeat steps 11 and 12 two more times over these 4 lines.
Step 14:
Make this mountain-fold over the piece in the middle
of the model.
Step 15:
Make another mountain-fold over the piece in the middle
of the model.
Step 16:
First, make a mountain-fold over the upper line.
Then, fold the piece that you folded to the backside
of the model back to the front by making a valley-fold
over the line below.
Step 17:
Repeat step 16 two more times over these 4 lines.
Step 18:
Fold the end below to the backside of the model
by making a mountain-fold over the very short blue
line.
The woodlouse is ready!
