Step 6:
Fold the spot on the right to the spot indicated by the arrow on the left.

Step 5:
Valley-fold in half.

Step 2:
Valley-fold in half

Step 4:
Repeat steps 1 to 3 starting with this line.

Step 3:
Unfold the model.

Step 10:
Prefold over this line, fold the edge below to the edge indicated by the upper arrow.
Then, unfold the model.

Step 8:
Valley-fold the edge on the left to the edge indicated by the arrow on the right.

Step 9:
Mountain-fold over this line.

Step 7:
Mountain-fold over this line.

Step 1:
This flower-paper is 3x3inch.
Valley-fold over this line.

Step 16:
Push the model inwards again, see arrows.

Step 15:
Fold the center downwards over these lines.

Step 12:
Start with a valley-fold over the two lines below, work clockwise from the line on the left and counter-clockwise from the line on the right.

Step 11:
Valley-fold over these prefolded lines.

Step 14:
Open the model from below, see arrow.

Step 13:
Prefold over this line

Step 21:
Valley-fold the three edges to the right.

Step 19:
Turn the model.

Step 20:
Push/press these three edges against each other, see arrows.

Step 18:
Repeat step 17 on the other 4 same places, see arrows.

Step 17:
Make an inside reverse fold over these lines.

Step 22:
Valley-fold over this line.

Step 28:
Fold over these two lines.

Step 25:
Make enough flowers for one completed plant.

Step 26:
The paper for the leaves is 3x3inch too.
Prefold over this line, then turn the paper.

Step 24:
Push the petal open with your finger, see arrow on the left. Then push the tip of the petal to the left, see arrow on the right.

Step 23:
Turn the model.

Step 29:
Valley-fold over these two lines.

Step 27:
Valley-fold over these two lines.

Step 32:
Valley-fold over these two lines.

Step 33:
Turn the model.

Step 31:
Valley-fold over these two lines.

Step 34:
Press the tip of the leaf flat between your fingers.

Step 30:
Press these two places flat.

Step 36:
Make enough leaves for one completed plant.
The flowers are glued to the stems of the leaves: Valley-fold the stem upwards, see purple line.

Step 37:
These leaves are used for the flowers.

Step 38:
Glue the opening at the back of the flower around the tip of the stem, see arrows.

Step 35:
Keep holding the tip between your fingers and push the stem to the right with your other hand, see arrow. Now the model gets a little crumpled.

Step 47:
Bend/fold/curve the stem, see arrows.

Step 46:
Rotate the brown paper around the main-stem, see arrows.

Step 44:
You can also use strong metal wire instead of this paper main-stem.

Step 42:
Valley-fold the top in half over the length.

Step 43:
Wrap extra tape around the top.

Step 45:
Wrap a crumpled brown a4-paper around the main-stem.

Step 41:
Wrap tape around the main-stem.

Step 40:
The main-stem is made of five a4-papers rolled up together.

Step 39:
Make enough of these flowers with leaf for one completed plant.

Step 49:
The two arrows on the left show where I glued the branches to the main-stem. The arrow on the right shows where I glued a leaf to a branch.

Step 48:
The bottom of the main-stem is placed in a pot filled with florist-foam or large paper balls.
The branches are made the same way as the main-stem, but I used smaller papers for them.