Step 1:
The other side of this selfmade paper is white.
Prefold over the four yellow lines.

Step 6:
Prefold over these two lines

Step 5:
Squash-fold the flap.

Step 2:
Fold the corners to the center.
Then turn the model.

Step 4:
Fold one flap upwards.

Step 3:
Valley-fold over the two lines at the bottom right. Then mountain-fold over the two diagonal lines. And valley-fold over the two lines at the top left.

Step 10:
Repeat steps 5 to 9 on the other three flaps.

Step 8:
Press the edges downwards / flat.

Step 9:
Fold the triangular flap upwards.

Step 7:
Fold the edge downwards

Step 16:
Pull the upper paper layer upwards.

Step 15:
Fold one edge on the left and one edge on the right upwards.

Step 12:
Fold the triangular flap to the inside.

Step 11:
Pull both ends outwards.

Step 14:
Repeat steps 11 to 13 three more times.

Step 13:
Press both ends towards each other again.

Step 21:
Fold the wing to the right. Then press the model flat by folding the edge indicated by the short arrow to the right.

Step 19:
Repeat steps 15 to 18 three more times.
Two flaps don't need to be folded upwards (=step 18), they will be the wings.

Step 20:
This is a flap which isn't folded upwards. Fold both edges outwards.

Step 18:
Fold the new / extra flap upwards.

Step 17:
Valley-fold over the yellow lines

Step 22:
Mountain-fold over the yellow line  (Step 24 shows te result).

Step 28:
Pull the flap outwards by making an inside reverse fold over the three yellow lines.

Step 25:
Pull the flap downwards by making an inside reverse fold over the three yellow lines.

Step 26:
Press the edges between the arrows against each other, then mountain-fold over the yellow line.

Step 24:
Open the model, see arrow

Step 23:
Repeat steps 20 to 22 on the left.

Step 29:
Mountain-fold the leg in half.

Step 27:
Open the model, see arrow

Step 30:
Repeat steps 24 to 29 on the left.

Step 31:
Valley-fold over both lines.

Step 32:
Fold the model in half.

Step 33:
Fold the edges below the arrow downwards, all in once. Do the same on the other side of the model.

Step 35:
Press the edge inwards on the spot indicated by the large arrow. And press the tip between the two small arrows flat.

Step 34:
Bend / fold the tip of each leg upwards (four legs)

Step 36:
Fold the wings downwards.

Step 37:
Make the same fold on the other side of the head.

Step 38:
Press or twist the tip flat, see arrows.