Step 1:Prefold over these 4 lines.
Then, turn the paper.
Step 2:
Valley-fold over these 2 lines.
Step 3:
Valley-fold over these 2 lines.
Step 4:
Valley-fold over this line.
The corner indicated by the arrow is pulled upwards
while you do this.
Step 5:
Press the place indicated by the arrow flat from above.
Step 6:
Repeat steps 4 and 5 on the places indicated by the
3 arrows.
Step 7:
Prefold over this line.
Step 8:
Valley-fold over these 2 lines.
Use the prefolded line of step 7 as guidance.
Step 9:
Valley-fold over the line at the left and mountain-fold
over the line at the right.
Step 10:
Valley-fold over this line.
The corner indicated by the arrow is pulled upwards
while you do this.
Step 11:
Press the place indicated by the large arrow flat from
above. And push the edge indicated by the small arrow
further downwards too.
Step 12:
Repeat step 10 and 11 on the other side, see brown line.
Step 13:
Fold over these 5 brown lines.
Fold the model in half over the red line while you
make these folds.
Step 14:
Turn the model.
Step 15:
Prefold over this line.
Step 16:
Open the model by pushing it outwards from the inside.
Step 17:
Push the top of the model downwards by making
mountain-folds over the brown lines, these lines are
prefolded in step 15.
Then, press the model flat from aside again, see arrows.
Step 18:
Valley-fold over this line.
The corner indicated by the arrow is pulled upwards
while you make this fold.
Mountain-fold over this line, make the
same fold on
making an inside reverse fold over these
3 lines
over these 3 lines (=valley-fold over
the line in the middle
Then, valley-fold over the short brown
line.
Do the same on the other side of the
tail.
